Technical Data - IKEA BITANDE Handbuch

ENGLISH
Problem
Water flows on the rear
plate of the refrigera-
tor.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working proper-
ly after making the above checks, contact
the After Sales Centre. You can find the list
at the end of this manual.
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.

Technical data

Dimensions of Instal-
lation
Height
Width
Depth
Net Volume
Fridge
Freezer
Defrost System
Fridge
Freezer
Possible cause
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
1780 mm
560 mm
550 mm
210 Litre
58 Litre
auto
auto
Solution
Decrease the room tempera-
ture.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera-
ture.
Only service is allowed to replace the light-
ing device. Contact your Service Center.
Closing the door
1. Clean the door gaskets.
2. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
Star Rating
Rising Time
Freezing Capacity
Energy Consumption
Noise Level
Energy Class
Voltage
Frequency
14
21 hours
4 kg/24h
0,808 kWh/24h
40 dB (A)
A+
230–240
50 Hz