Termofor Compact 2013 Inhaltverzeichnis Seite 38

For installation of the model «Vitra» on the site of operation it is necessary:
1. Unscrew self-tappers 8 ps. that fixes a door with a frame to a fuel
canal and remove a door; (see Figure 8)
2. Install the stove on the site of operation (edge of a fuel canal shall
emerge from another side of a baffle);
3. Install back a door with a frame. I will be fixed by self-tappers
For the models «Compact 2013» and «Compact 2013 WT», the stove
is installed on the site and then a door put on a fuel canal. A door is
included in a delivery set.
Installation of a door on the models «Compact 2013» and «Compact
2013 WT»:
1. Remove a stop quick-detachable collar, then remove the axis out of the door, see figure 9.a;
2. Install the door on sleeves of a fuel canal and unite holes;
3. Set an axis from bottom to top through holes. Place a groove under a collar in the top part of an axis, see
figure 9.b;
4. Install a stop quick-detachable collar in a groove on an axis, see figure 9.c.
The stones shall be set into the stones section after the end of the stove mounting and its connection to all the
necessary systems.
8.7. Stove pipe assembly
During the use of the stove, the stove pipe shall be treated very carefully.
Stove pipe (chimney stack) – is the means of air ventilation of exhausted gases, it provides the draught that
facilitates the constant air intake into the heating equipment necessary for normal burning process. The stove is
designed only for operation with natural draught.
The stove shall have its own stove pipe.
ATTENTION! It is prohibited to connect the stove to any air ducts except for the cases when the air duct is
designed only for operation as the stove pipe.
ATTENTION! It is prohibited to connect the stove to the stove pipe that is connected to another equipment
or heating unit.
ATTENTION! The stove does not draw. The draught is made only with the stove pipe.
The stove pipe has two functions for the stove trouble-free operation. The first – is the piping of exhaust gases
generating during the fuel combustion. The second – is draught for air intake into the fire chamber for combustion
maintenance.
Draught – is the natural air or gases movement through the stove pipe. It generates due to the feature of warm
air to go upwards.
As far as the warm air moves in the stove pipe the low pressure is generated in the place of the stove
connection to the stove pipe. The greater pressure from the outside of the stove makes the air move into the area of
lower pressure – into the area of fire box. Thus the air intake into the fire chamber happens. This constant air inflow
36
I
I
a)
Figure 9. Assembly of the door under installation of the stove.
installation of the stove
b)
c)
Figure 8. Door
disassembling under
«Vitra»