Eibenstock EHB 32 Originalbetriebsanleitung Seite 17

Tool Protection
Wrong handling can cause damages on the tool and injuries of the user.
Therefore, the following instructions should be observed:
Do not allow blocking of the tool.
Only use original accessories made by EIBENSTOCK.
Switching on and off
Short-Time Operation
Switching-on: press the on/off switch
Switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off: press the on/off switch and release it again
Attention!
!
Only press the lock-on button when using a stand. In case of
every stop of the machine, the lock-on button has to be
released immediately by pressing the on/off switch.
Consequently, you can avoid an unintentional restart of the
machine (physical hazard).
The machine is equipped with two selecting wheels, which allow an
adjustment of load speed and torque.
These are in the intermediate block between handle and motor housing.
The speed adjustment (SPEED) is on the same side like the arrestor
button.
Torque adjustment (POWER) is on the opposite.
Additional the machine has a change-over switch for reverse action.
It is on the top side between the selecting wheels.
Use the change-over switch only when the spindle is stopped.
Mode of Action of Speed Adjustment
Position "I" means minimum, position "IIIII" maximum speed.
Please pay attention that a permanent use with reduced speed can cause
an overload because the motor then gets less cooling air and therefore the
machine will be overheated much faster.
So always use preferably the mechanical speed selection for changing the
speed.
17