Using The Sony Tv Direct Function; Preparation; Number Buttons; Operation - Sony DAV-SB100 Betriebsanleitung

Using the SONY TV DIRECT Function

SONY TV DIRECT allows you to turn on your SONY TV
and this system, change the system mode to "CD/DVD,"
and then switch the TV's input source you set with one
button push.

Preparation

Register the TV's input source connected to this
system.
Press and hold TV/VIDEO while entering the
1
code for the TV's input source to connect this
system (see table below) using the number
buttons.
TV's input source is selected
If you successfully set the TV's input source code,
the TV button flashes twice slowly. If the setting is
unsuccessful, the TV button flashes five times
quickly.
34
SONY TV DIRECT
TV

Number buttons

TV/VIDEO
TV CH +/-
By pressing Number
TV/VIDEO 0
1
2
3
4
5
6
7
8
Press and hold TV CH + while entering the code
2
for transmit time (see table below) using the
number buttons.
The transmit time from the remote is selected.
If you successfully set the transmit time code, the
TV button flashes twice slowly. If the setting is
unsuccessful, the TV button flashes five times
quickly.
By pressing Number
TV CH + 1
2
3
4
5
6
7
8

Operation

Point the remote to the direction of TV and this system,
then press SONY TV DIRECT once.
While transmitting the code from the remote, the TV but-
ton flashes.
Notes
The function is only for SONY TV series.
If this function does not work, change the transmit
time. The transmit time varies depending on the TV.
If distance between TV and this system is too far, this
function may not work. Install the system near the TV.
Keep the remote pointed in the direction of the TV
and this sysetm whlie the TV button is flashing.
TV's input source
No input source
(Default)
VIDEO1
VIDEO2
VIDEO3
VIDEO4
VIDEO5
VIDEO6
COMPONENT 1
INPUT
COMPONENT 2
INPUT
Transmit time
0.5 (Default)
1
1.5
2
2.5
3
3.5
4