DESCRIPTION OF THE DEVICE
Features
LED logo projector
¨
Equipped with one white 3 W COB LED
¨
You can change the projector motive without tools
¨
For metal and glass gobos (D = 37 mm – Image = 30 mm), not included in delivery
¨
Beam angle 22°
¨
For permanent installation
¨
Switch-mode power supply for operation between 100 and 240 volts
¨
Ready for connection via power cord and safety-plug
Overview
INSTALLATION
Inserting/Exchanging gobos
If you want to use other shapes or patterns, or if gobos should be exchanged, please proceed as follows:
1. Disconnect the logo projector from the power supply.
2. Remove the lens tube (front projector part) by turning it counterclockwise from the logo projector. (a)
3. Rotate the gobo holder counterclockwise from the lens tube. (b)
4. Turn the ring of the gobo holder counterclockwise (c), insert/exchange the gobo, and then screw the ring
of the gobo holder clockwise to tighten.
(1) Fine focus
(2) Objectiv lens tube (with integrated gobo
holder)
(3) Housing
(4) Joint holder
(5) Power supply
(6) Montage foot
13/16
00103050.DOC, Version 1.0