Eurolite Ir-7 Remote Control - EuroLite LED PS-4 HCL Bedienungsanleitung

10 channel mode
Channel:
1
2
3
4
5
6
7
Dimmer
8
Strobe
9
Programs via DMX
10
Speed via DMX

EUROLITE IR-7 remote control

Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
Value: Function:
000 - 255 Red
000 - 255 Green
000 - 255 Blue
000 - 255 White
000 - 255 Amber
000 - 255 UV
000 - 255 Increasing brightness
000 - 009 No function
010 - 255 Strobe with increasing speed
000 - 009
No function
010 - 199 Auto mode via DMX
200 - 255 Sound mode via DMX
000 - 255 Increasing speed in Auto /Sound modes via DMX
1
The device must be activated for remote control. For this,
under menu item InFr, press the ENTER button to confirm
activation.
2
When actuating a button, always hold the remote control in
the direction of the sensor. There must be visual connection
between the remote control and the sensor.
3
The remote control is supplied with a battery inserted. An
insulating foil between the battery and the battery contacts
prevents the battery from being discharged during storage.
Prior to the first operation remove the foil from the battery
support on the rear side of the remote
control. Otherwise operation of the remote
control is not possible.
4
If the range of the remote control decreases
(10 meters as a maximum), replace the battery. For this
purpose, on the rear side of the remote control press the
small bar with the groove to the right and at the same time
remove the battery support. For operation, one 3 V button
cell type CR 2025 is required. When inserting, pay attention
that the positive pole of the button cell shows upwards in
the support.
CAUTION!
not be disposed of with regular domestic waste!
26/28 00093702.DOC, Version 1.1