Dmx512 Control; Master/Slave Operation - EuroLite bar 6, bar 12 Bedienungsanleitung

DMX512 control

The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Device 3
Starting address 9
1: Ground MIC
2: Signal (-)
DMX IN MODE ENTER
3: Signal (+)
120 Ohms
Only use a DMX cable and 3-pin XLR plugs and connectors in order to connect the controller with the fixture
or one fixture with another.
Occupation of the XLR connection:
If you are using controllers with this occupation, you can connect the DMX output of the controller directly
with the DMX input of the first device in the DMX chain. If you wish to connect DMX controllers with other
XLR outputs, you need to use adapter cables.
Building a serial DMX chain:
Connect the DMX output of the first device in the DMX chain with the DMX input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution: At the last fixture, the DMX cable has to be terminated. Plug the terminator with a 120
between Signal (–) and Signal (+) in the DMX output of the last fixture.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the desired master mode for the master device. Set the slave mode for all slave devices. Please refer to
further instructions under Control Board.
the devices will not work at all, or will not work properly.
1: Ground
SAFETY ROPE 2: Signal (-)
DMX OUT DMX IN
3: Signal (+)
Device 2
Starting address 5
MIC
SAFETY ROPE
MODE ENTER DMX OUT
24/32
Device 1
Starting address 1
1: Ground MIC
2: Signal (-)
DMX IN MODE ENTER DMX OUT
3: Signal (+)
DMX-512 Controller
Ω resistor
00107423.DOC, Version 1.0
SAFETY ROPE