Troubleshooting; Remote Control Does Not Operate - Octagon SF 908G HD - Difference Bedienungsanleitung

-

Troubleshooting

Problem
Does not display any message
on the front panel.
No Picture
Poor picture quality
No Sound
Remote Control does not
operate
No or Bad Signal
 Check the main power cable and check that it is plugged into a
suitable power outlet.
 See 'Does not display any message on the front panel' above.
 Check the video output port is firmly connected to the TV or
VCR.
 Check that you have selected the Video Input on your TV.
 Press the STB button on the remote to assure you are
controlling the STB and no other device with the remote.
 Check the brightness level of the TV.
 Check the resolution that your TV supports, and set the proper
resolution with the remote Resolution button to obtain a
picture.
 See 'No Picture' above.
 Check the signal level, if this is low then tries adjusting the
alignment of your dish.
 See 'No Picture' above.
 Check the volume level of the TV and STB.
 Check the Mute status of the TV and STB.
 Point remote control directly towards the STB.
 Check that the STB button lights up when you press any
button
 Check and replace batteries.
 Check the LNB ; Replace the LNB if necessary.
 Check the cable from the LNB.
 Check the position of the dish; realign dish if necessary.
 If you are using a DiSEqC 1.0 switch, check that you have
connected and programmed the LNBs to the correct
connections on the switch.
 Check the 'Signal Level' and the 'Signal Quality' .
48
Solution