Playing Usb Devices And Memory Cards; Audio Recordings - Omnitronic DRT-1000 Bedienungsanleitung

7.2 Playing USB devices and memory cards

1. Insert USB devices into the USB port. Insert a memory card with the contacts pointing downwards and
the notched corner to the right so far into the card slot until it is engaged. To eject a memory card,
slightly press it into the slot until it comes out and can be removed. CAUTION! Never attempt to remove
USB devices or memory cards in play mode. Otherwise damage or loss of data may occur.
Regarding memory cards and USB storage devices
• This unit supports SD and SDHC memory cards.
• This unit supports MSC (Mass Storage Class) USB storage devices 1.0, 1.1, 2.0 including
external portable flash memory devices and digital audio players. However, hard discs, optical
discs such as external CD/DVD drives, and USB devices connected to a USB hub will not be
recognized.
• Depending on the device used, proper playback may not be possible with all USB storage
devices.
• When inserting a data carrier with a large number of folders and files, some time may be required
to read in the contents.
2. Press the selector switch AUDIO SELECT to switch from the record to a USB device or a memory card.
The unit must be in pause mode. The first actuation of the button will select the USB port, the next
actuation will select the SD card slot and the next actuation will switch the unit back to the record. The
LEDs will light to verify which source is active. During the read-in of a USB device or memory card the
corresponding LED will be flashing.
3. Press the button
restarted by pressing the button again.
4. For selecting titles and for fast forward/reverse use the buttons
pressed, the unit will advance one title. By pressing the button
title and with each further actuation, the unit will go back another title. For fast forward, keep the button
pressed, for fast reverse keep the button

7.3 Audio recordings

1. Switch to phono with the selector switch AUDIO SELECT (LED PHONO lights).
2. Shortly actuate the button REC MODE/REC STOP to activate the recording mode (the corresponding
LED will be flashing). If a USB device is connected for the recording, the LED USB will be flashing to
indicate that the device is selected. For a memory card, the LED SD will be flashing. If both a USB and a
memory card is inserted, the USB device is automatically selected as memory medium.
3. Press the button
recording in the MP3 format with 128 kbit/s and 44.1 kHz sampling rate.
4. With the control REC LEVEL adjust the recording level. The overload indication REC CLIP should not
light up or only light up shortly during signal peaks. If it lights permanently, reduce the level
correspondingly.
5. To stop the recording, keep the button MODE/REC STOP pressed for about three seconds. The LED of
the button REC MODE/REC STOP extinguishes and the LED of the memory medium stops flashing.
Hint
For processing the recordings on a computer, different programs are available as freeware on the
internet. We recommend the easy-to-use audio editor Audacity (http://audacity.sourceforge.net/).
6. After use, switch off the unit with the power switch.
to start playback. By pressing the button
. The recording starts. On the memory medium, a new folder will be created with the
and
, the unit will go to the beginning of the
pressed.
21/23
playback can be interrupted and
. Each time the button
00048594.DOC, Version 1.0
is