Assembly And Basic Adjustments; Mounting The Turntable Platter - Omnitronic DRT-1000 Bedienungsanleitung

21 Analog line output
Analog audio output (RCA, left/right) with line level for
connecting an amplifier, a mixer or other units with line
level inputs.
22
Power input
Plug in the supplied power cable here.

5. ASSEMBLY AND BASIC ADJUSTMENTS

The headshell, the turntable platter and the counterweight for the tone arm are separately packed to prevent
damage to the turntable during transportation. After unpacking, the parts can be easily assembled. The
packing material should be kept for transportation purposes.

5.1 Mounting the turntable platter

1. Place the rubber driving belt over the bottom of the platter (Fig. 1).
2. Set up the turntable on a plane, stable ground and place the turntable platter on the axle of the turntable
(Fig. 2).
3. Turn the platter by hand until one of the cutouts is near the top right corner and the driving axle of the
motor is visible.
4. The rubber driving belt is visible through the cutouts of the turntable platter. Seize the driving belt and
place it over the driving axle (Fig. 3).
5. Place the supplied slipmat on the turntable platter.
23 Power switch
Press the power switch to turn the unit on and off.
18/23 00048594.DOC, Version 1.0