Operating Elements And Connections - Omnitronic DRT-1000 Bedienungsanleitung

4.2 Operating elements and connections

1 USB port
USB port (type A) for inserting a USB storage device.
2
SD card slot
Slot for inserting an SD(HC) card.
3
Button
To switch between start and pause for the platter.
4 Platter
5 Target light
6 Headshell with phono cartridge system
7 Buttons to select speed
• for 33O RPM press the left button, the LED above the
button lights (basic setting)
• for 45 RPM press the right button, the LED above the
button lights
• for 78 RPM press both buttons simultaneously, the
LEDs above the buttons light
8 Button REVERSE
To switch between forward and reverse run.
9
Button
To switch between play and pause for an external data
carrier and to start a recording.
10
Buttons and
For selecting titles and for fast forward and reverse on the
selected data carrier.
11
Button REC MODE/REC STOP
Short actuation of the button activates the recording
mode (LED will be flashing) and long actuation stops the
recording (LED off).
12 Selector switch AUDIO SELECT
For switching between the input sources USB, SD and
phono for playback. The LEDs will verify which source is
active.
13 Adaptor for single records
14 Control REC LEVEL
For adjusting the recording level. If the clip LED lights up,
the signal is overloaded.
15 Tone arm lift
16 Anti-skating adjustment
17 Counterweight scale
18
Counterweight for the tone arm
19 Tone arm rest with locking lever
20 On/off switch for the motor
17/23 00048594.DOC, Version 1.0