Clint F3 Bedienungsanleitung Seite 17

11 Scan Modes
Auto Scan
The Auto scan setting will scan up or down depending on where the
starting frequency is. Once it finds a station it will stop.
There are 2 options to use when using this function.
NOTE: Ensure you are in the FM mode before following the below
steps.
1. Press and hold the INFO/MENU button for 3 seconds.
2. When the < Scan Setting > option appears, press the ENTER button.
3. You will have the choice of either <Strong Stations Only> or
<All Stations> using the
Strong stations only, will only stop at stations with a strong signal.
All stations will stop at any station found with a strong or weak
signal.
4. Make your choice by pressing the ENTER button to activate the
setting.
Now when you press and hold the BACK/SCAN button the auto scan
searches depending on what setting you chose.
Factory Reset
To reset the radio to the factory settings follow the below steps.
1. Press and hold the INFO/MENU button for 3 seconds.
2. When the <Scan Setting> option appears press either
find <System>, press the ENTER button.
or buttons.
www.clintdigital.com
or and
17