Settings Via The Menu; Basic Settings And Reset - Monacor UF-20S/5 Bedienungsanleitung

2) In normal mode, the display shows the fol-
lowing information:
Symbol
ID
UF-20
G
CH
MHz
Fig. 5 Display information
3) To switch off, keep the button
2 seconds until the display indicates
OFF

3.3 Settings via the menu

All settings are made via a menu:
1) To call up the main menu (fig 2), keep the
button SETUP (7) pressed for two seconds
until the menu appears on the display (6)
2) Turn the knob PUSH /CONTROL (8) to select
the desired menu item Then press the knob
to call up the menu item
3) Turn the knob to make the setting or, when a
submenu appears, turn the knob to select a
submenu item and press the knob to call it up
4) If multiple setup functions are available for a
menu item (e g group number and channel
number), press the knob to go from one func-
tion to the next one
5) To save a setting, press the button SETUP The
display briefly indicates
main menu reappears
18
Meaning
indication which of the two antennas
(A or B) receives the radio signal
of the higher quality; if no signal is
received, an X appears
key lock activated
audio output level adjusted:
, ... ,
Mute -50 -1 Max.
identification number
battery status of the wireless
microphone or pocket transmitter;
if no signal is received or if the
microphone/transmitter is muted,
the message appears instead
MUTE
of the battery symbol
device name, to be edited as
desired (10 characters)
group number (1 ... 15)
channel number (1 ... 63)
transmission frequency
(530 000 ... 605 000 MHz)
Saving
change, press the button EXIT (9) The main
menu reappears
6) To exit the main menu, press the button EXIT
or select the menu item
press the knob PUSH /CONTROL
All setting options via the menu can be found in
the following chapters

3.4 Basic settings and reset

1) If it is difficult to read the display, call up the
contrast setting via the menu item
trast
Turn the knob PUSH /CONTROL to set the
contrast Press the button SETUP to save the
setting The main menu reappears
button EXIT or to change another setting, turn
the knob PUSH /CONTROL to select the cor-
responding menu item and press the knob
to call it up
pressed for
2) To coarsely set the output level (line or mi-
Power
crophone level) for the XLR jack (14), go to
the menu item
3) The antenna inputs are factory-set to supply a
12 V operating voltage for antenna amplifi-
ers (e g UB-900B) If no antenna amplifier is
used, deactivate the 12 V operating voltage via
the menu item
4) Via the menu item
vice name can be entered (10 characters
max ) which appears on the display (e g
UF-20 as shown in fig 1) When multiple
pairs of microphones/receivers are used, this
before the will make it easier to distinguish between the
pairs and to identify them After the menu
To exit a (sub) menu item without a
:
ast
Setup Cont
To deactivate the main menu, press the
a. Output Level
Output Level
Line
Mic.
b. Antenna Power
Antenna Power
ON
OFF
c. User Name
and then
g. Exit
d. Con-
Fig. 6
:
Fig. 7
:
Fig. 8
, a de-