Applications; Conformity And Approval; Operation; Connections - Monacor UF-20S/5 Bedienungsanleitung

3 if malfunctions occur
In any case the units must be repaired by skilled
personnel
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug
•
For cleaning only use a dry, soft cloth; never
use water or chemicals
•
No guarantee claims for the units and no
liability for any resulting personal damage or
material damage will be accepted if the units
are used for other purposes than originally
intended, if they are not correctly connected
or operated, or if they are not repaired in an
expert way
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful
to the environment

2 Applications

Combined with a matching transmitter from JTS,
the receiver UF-20R /5 or UF-20S/5 creates a
wireless audio transmission system which is ide-
ally suited for professional stage applications The
REMOSET function is a most convenient feature
®
for operating the system: Simply press a button
and, via a 2 4 GHz radio signal, the microphone/
pocket transmitter is matched to the transmission
frequency selected on the receiver
The receivers use "True Diversity" technology:
The signal sent from the wireless microphone or
pocket transmitter is received by two antennas
and amplified in two separate receiver sections
The signal of the highest quality is then processed
The transmission range depends on local con-
ditions; in open-field conditions, the minimum
range is 100 m
The following JTS transmitters can be combined
with the receivers:
JSS-20/5 Order No 25 7200
Dynamic hand-held microphone with integrated
transmitter
UF-20TB/5 Order No 25 7230
Pocket transmitter for JTS microphones with
4-oole mini XLR plug
16

2.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the receivers UF-20R /5 and UF-20S/5 com-
ply with the directive 2014/53/EU The receivers
are generally approved for operation in EU and
EFTA countries; they are licence-free and require
no registration The EU declarations of conformity
are available on request from MONACOR INTER-
NATIONAL

3 Operation

The UF-20R /5 and the UF-20S/5 can be placed
on a table as desired However, the UF-20R /5
can also be installed into a rack (482 mm /19")
In the rack, it requires one rack space (1 RS =
44 45 mm)
The receiver UF-20R /5 is equipped with
two receiver sections; connection and operation
of these sections are identical Therefore, the
description below refers to one receiver section
only

3.1 Connections

1) Insert the two antennas (2) provided into the
antenna jacks (17) and put them in a vertical
position
Hints:
1 To increase the range and the interference resist-
ance, the antenna amplifiers UB-900B can be in-
serted The amplifiers are supplied with power via
the antenna jacks of the receiver (chapter 3 4)
2 On the receiver UF-20R /5, the set of antenna
jacks RTF-2U can be used to fix the antennas at
the front of the receiver: Insert the jacks through
the mounting holes (1), fasten them and connect
them to the antenna jacks (17) via the extension
cables provided
2) To connect the subsequent unit, e g mixer
or amplifier, two audio outputs are available:
– XLR chassis plug (14)
balanced output (phantom power resistant)
for connection to a microphone input or
line input (The output level can be switched
accordingly, ☞ chapter 3 4 )
– 6 3 mm jack (15)
balanced output for connection to a line
input