What To Do If - Electrolux EWW 148540 W Benutzerhandbuch

the procedure until water stops flowing
out;
6. clean the pump if necessary as previous-
ly described;
7. replace the emergency emptying hose
in its seat after having plugged it;
8. screw the pump again and close the
door.
Frost precautions
If the machine is installed in a place where
the temperature could drop below 0°C, pro-
ceed as follows:

WHAT TO DO IF...

Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engi-
neer. Before contacting your local Service
Centre, please carry out the checks listed
below.
During machine operation it is possible that
the red pilot light of button 8 blinks, one of
the following alarm codes appears on the
display and some acoustic signals sound ev-
Problem
The washing machine does
not start:
The machine does not fill:
The machine fills then emp-
ties immediately:
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Place the end of the emergency empty-
4. Screw the water inlet hose back on and
5. When you intend to start the machine
ery 20 seconds to indicate that the machine
is not working:
•
•
•
Once the problem has been eliminated,
press the button 8 to restart the pro-
gramme. If after all checks, the problem per-
sists, contact your local Service Centre.
Possible cause/Solution
The door has not been closed. E40
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the button 8 has
not been pressed.
• Please turn the selector dial and press the button 8 again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
The Child Safety Lock has been activated.
• Deactivate the Child Safety Lock.
The water tap is closed. E10
• Open the water tap.
The inlet hose is squashed or kinked. E10
• Check the inlet hose connection.
The filter in the inlet hose is blocked. E10
• Clean the water inlet hose filter.
The door is not properly closed. E40
• Close the door firmly.
The end of the drain hose is too low.
• Refer to relevant paragraph in «water drainage» section.
ing hose and that of the inlet hose in a
bowl placed on the floor and let water
drain out.
reposition the emergency emptying
hose after having put the cap on again.
up again, make sure that the room tem-
perature is above 0°C.
: problem with the water supply.
: problem with the water draining.
: door open.
electrolux 23