Operating Determinations - EuroLite MD-1015 Rotary Motor Bedienungsanleitung

If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
For the version without power-plug:
The electric connection must only be carried out by a qualified electrician!
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the
power-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a mirrorball motor for turning mirrorballs up to a maximum diameter of 30 cm. The maximum
charge of the whole installation must not exceed 3 kg.
This product is only allowed to be operated with an alternating voltage of 230 V, 50 Hz and was designed for
indoor use only.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
fixture.
Please use the original packaging if the device is to be transported.
If this mirrorball motor will be operated in any way different to the one described in this manual, the product
may suffer damages and the guarantee becomes void. Furthermore, any other operation may lead to
dangers like short-circuit, burns, electric shock, crash etc.
INSTALLATION
Installation for home use:
The installation of the mirrorball has to be built and constructed in a way that it can hold 5 times the weight
for 1 hour without any harming deformation.
Procedure:
The mirrorball should be installed outside areas where persons may walk by or be seated.
DANGER TO LIFE!
DANGER TO LIFE!
Please consider the EN 60598 norms during the installation!
The installation must only be carried out by a qualified electrician!
8