EuroLite MD-1015 Rotary Motor Bedienungsanleitung Seite 9

The installation spot must be chose in a way that the motor can be installed in an absolutely horizontal
position.
The motor and the mirrorball have to be installed out of the reach of people.
Caution: Mirrorballs may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the motor!
Before rigging make sure that the installation area has to hold a minimum of 30 kg point load.
Please install the mirror ball motor via all 4 fixation holes.
Do only use appropriate screws and make sure that the srews are properly connected with the ground.
Connection to the mains
For the version with power-plug:
Connect the device with the power plug to the mains.
For the version without power-plug:
Connect the device with the 3-pole power supply cable to the mains.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
The mirrorball has to be connected via an appropriate installation (see above) with the motor. We
recommend to use the Chain for Mirrorballs up to 50 cm certified, 33 cm, No. 50301612 or Chain for
Mirrorballs up to 50 cm certified, 100 cm, No. 50301614.
The installation material must never include abrading material e. g. steel cables in order to avoid
The length of the chain must never exceed 100 cm.
Make sure that the rotation of the mirroball is never slowed down or stopped by decoration material etc.
Make sure that no side forces can impact on the installation.
Please check in regular intervals, if the key ring or chain links have been deformed. Uninstall the mirrorball
immediately in such a case.
Installation for professional use (e. g. discotheques, theatres, etc.):
Please consider the BGV C1 (before VBG 70) and EN 60598-2-17 norms during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the mirrorball has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
International
L
N
material wearing.
DANGER TO LIFE!
9