Using The Surround Mode; Adjusting The Sound Level; Playing Back Ipod - JVC TH-LB2-W Bedienungsanleitung

Operations
(continued)
Selecting the input source
Press one of the input buttons to select the input
source.
DIGITAL 1:
DIGITAL 1 (for the optical connection)
DIGITAL 2:
DIGITAL 2 (for the coaxial connection)
ANALOG:
ANALOG IN (for the analog connection)
Adjusting the volume
Press VOLUME +/–.
Adjusts the volume within the range of 0 (MIN) to 40 (MAX).
CAUTION
Set the volume to the minimum level before starting any source. If the
volume is set to a high level, the sudden blast of sound may damage
your hearing and blow out the speakers.
Turning off the sound temporarily
Press MUTING.
•
To restore the sound, press the button again or press VOLUME +
to adjust the volume.
Maintaining steady volume for different
input sources
You can set your desired volume level for different input sources to
avoid volume fluctuation when changing from one source to the
other—TruVolume (TVOL).
Press TVOL.
Each time you press the button, TruVolume is turn on and off (TVOL
ON and TVOL OFF scroll on the display).
Changing the display brightness
Press DIMMER.
Each time you press the button, the display brightness changes
with the following scrolling message:
DIMMER OFF (normal) \ DIMMER 1 (darker) \ DIMMER 2
(darkest)

Using the surround mode

You can listen to a more realistic sound than stereo sound using
surround—StudioSound HD (SSHD).
Press SSHD.
Each time you press the button, surround mode is turn on and off
(SSHD ON and SSHD OFF scroll on the display).

Adjusting the sound level

You can adjust the bass and treble sound level within the range of
–3 to +3.
1
Press BASS/TREBLE repeatedly to select the sound
you want to adjust.
– BASS: Adjusts the bass sound level.
– TREBLE: Adjusts the treble sound level.
2
Press UP/DOWN to adjust the level.
NOTE
The change in the bass and treble sound level of the speakers differ
depending on the incoming signal of the input source.

Playing back iPod

Connecting iPod
While the power is turned off...
1
Push the tray (8) to open the dock for iPod.
2
Connect iPod to the connector.
•
You cannot connect iPod to the unit if it is covered by something
or with accessories attached. Remove them before connecting.
•
Keep iPod in a straight position while connecting/disconnecting
it.
• Do not carry the unit with iPod connected. It might cause
damage to the dock for iPod or you might drop iPod.
•
Do not touch or hit the iPod terminal pins or connector pins in
the dock for iPod directly. Doing so might cause damage to the
connector pins.
•
While the power is turned on, iPod can be charged.
7
iPod (not supplied)