Connecting External Components; Connecting The Power Cord; Operations; Basic Operation - JVC TH-LB2-W Bedienungsanleitung

Connecting external
components
You can connect an analog component to the ANALOG IN terminal
and digital components to the (OPTICAL) DIGITAL IN 1 and
(COAXIAL) DIGITAL IN 2 terminals.
You can also connect a subwoofer to the SUBWOOFER PRE-OUT
terminal.
RCA pin plug cord
(not supplied)
Rear of the unit
R
(COAXIAL)
DIGITAL ANALOG
IN 2 IN
Red
Digital coaxial
cord
(not supplied)
DVD Player, etc.
(not supplied)

Connecting the power cord

Connect the supplied AC adaptor to the DC IN jack on the unit. Then
connect the supplied AC power cord to the AC adaptor, and plug it
in a wall outlet.
CAUTION
• Disconnect the power cord before cleaning or moving the unit.
•
To avoid the risk of fire and to prevent damage,
–
Do not use any AC adaptors other than the one supplied.
– Do not use the supplied AC adaptor for other equipment.
Subwoofer
(not supplied)
L
(OPTICAL)
DIGITAL
IN 1
White
RCA pin plug Digital optical
cord cord
(not supplied) (not supplied)
TV, etc. (not supplied)

Operations

Basic operation

Turning on/off the power
Press .
NOTES
• A small amount of power is consumed even when the power is
turned off (standby mode). During standby mode, the STANDBY
indicator lamp on the front panel lights up. Unplug the power cord
from the AC outlet to turn the power off completely.
•
You can also turn on the power by pressing one of the input buttons
(DIGITAL 1, DIGITAL 2 or ANALOG) or iPod 6.
Activating/deactivating APS (Auto Power
Save)
The System automatically turns off to save the power.
Press and hold APS.
Each time you press and hold the button, Auto Power Save is turn
on and off (APS ON and APS OFF scroll on the display).
• The System automatically turns off to save the power when one
of the following situations continues for 29 minutes:
•
For all sources:
– When the volume is set to 0.
–
When muting is activated.
For DIGITAL 1/DIGITAL 2:
– When the optical cord or coaxial cord is not connected, or
there is no signal.
For iPod:
– When iPod is not connected to the unit.
When one of the situations occurs...
The APS indicator is shown for 1 second every 1 minute and starts
flashing 30 seconds before the System turns off.
6