Disconnecting A Device; Using The Bluetooth Cellular Phone - JVC KD-BT22 Bedienungsanleitung

You can set the unit to connect the Bluetooth device
automatically when the unit is turned on. (See
"Auto Cnnct" on page 37.)

Disconnecting a device

Perform steps 1 and 2 on page 16, then...
Select "Discn Phone" or "Discn Audio."
"Disconnecting..." flashes, then "Disconnected (and
device name)" appears on the display when the device
is disconnected.
Using the Bluetooth cellular
phone
Making a call
You can make hands-free calls using the unit.
The built-in microphone is behind
this corner of the unit.
The sounds comes out from the connected speakers.
• When appears on the display, you can
move back to the previous display by pressing
number button 3.
1
2
Select "Call."
18
3
Select the method to make a call.
• Dialed *: Shows the list of the phone numbers
you have dialed. Go to the following step.
• Received *: Shows the list of the received calls.
Go to the following step.
• Phonebook: Shows the name/phone number of
the phone book of the unit. Go to the following
step. To copy the phone book memory, see
page 20.
• Preset: Shows the list of preset numbers. Go
to the following step. To preset numbers, see
page 20.
• Dial Number: Shows the phone number entry
screen. See "How to enter phone number" on
page 19.
• Voice Dial (Only accessible when the connected
cellular phone has the voice recognition system):
Speak the name (registered words) you want to
call.
* Displays only when the dialed or received number
is made through the unit.
4
Select the name/phone number/preset
number you want to call.
• When the sound is stopped or interrupted during the
use of a Bluetooth device, turn off, then turn on the
unit.
– If the sound is not yet restored, connect the device
again. (See "Connecting a registered device" on
page 17.)