Turning Off The System - PIONEER DJ DDJ-SR2 Bedienungsanleitung

Playing tracks and outputting the sound
The following is the procedure for outputting the channel 1 sound as an
example.
Set the volume of the components (power amplifier, powered speak-
ers, etc.) connected to the [MASTER 1] and [MASTER 2] terminals to
an appropriate level. Note that loud sound is output if the volume is
set to high.
3
4
5
6
7
8
3 INPUT SELECT switch
4 TRIM control
5 EQ (HI, MID, LOW) controls
6 Headphones CUE button
7 Channel fader
8 Crossfader
9 MASTER LEVEL control
a BOOTH MONITOR control
b HEADPHONES MIXING control
1 Set the controls, etc. as follows.
Name of part
MASTER LEVEL control
INPUT SELECT switch
TRIM control
EQ (HI, MID, LOW) controls
Channel fader
12
En
9
a
b
Operation
Rotate it clockwise until it
stops.
Set to the [DECK] position.
Rotate it clockwise until it
stops.
Set to the center position.
Move it forward.
2 Press the [ ] button to play the track.
3 Turn the [TRIM] control.
Adjust the [TRIM] control to confirm that the channel level indicator
lights up in orange at the highest volume.
4 Move the channel fader forward.
5 Rotate the [MASTER LEVEL] control to adjust the
sound level of the speakers.
Adjust the level of sound output from the [MASTER 1] and [MASTER 2]
terminals to an appropriate level.
Monitoring sound with headphones
Set the controls, etc. as follows.
Name of part
HEADPHONES MIXING control
HEADPHONES LEVEL control
1 Press the headphones [CUE] button for the channel 1.
2 Rotate the [HEADPHONES LEVEL] control.
Adjust the level of sound output from the headphones to an appropriate
level.
Note
This unit and the Serato DJ software provide various functions that
enable individualistic DJ performances. For details on those functions,
see the manual provided for the Serato DJ software.

Turning off the system

1 Close [Serato DJ].
A confirmation message for closing the software appears on the screen.
Click [Yes] to close.
2 Press the [STANDBY/ON] switch on the rear panel of
this unit to set this unit to standby mode.
3 Disconnect the USB cable from the computer.
Operation
Set to the center position.
Rotate it clockwise until it
stops.