Preparing For Use; Baby Unit; Parent Unit - Philips Avent SCD501/00 Benutzerhandbuch

4 Preparing for use

4.1 Baby unit

The baby unit is mains-operated and has a fixed
mains cord.
Put the adapter of the mains cord in a wall
1
socket to connect the baby unit to the mains.

4.2 Parent unit

The parent unit runs on mains power. You can also
insert batteries to allow mobile use of the parent
unit.
4.2.1 Mains operation
Put the small plug in the socket in the side
1
panel of the parent unit and put the adapter
in a wall socket.
4.2.2 Inserting the batteries
If the parent unit is not close to a wall socket,
you can run it on two 1.5V R6 AA alkaline
non-rechargeable batteries or two 1.2V R6
AA rechargeable batteries (not supplied). The
operating time on full batteries is up to 24 hours,
depending on the type of batteries used and on
how long and how often you use the parent unit
on batteries.
4213_355_5006_2_DFU-Redesign_A5_v3.indd 5
Note:
D
Please note that the parent unit does not charge
the batteries when it is connected to the mains.
You can use rechargeable batteries in the parent
unit, but you need to charge them in a separate
charger.
Warning:
B
Unplug the parent unit and make sure your
hands and the unit are dry when you insert the
batteries.
Press the release button (1) to unlock the
1
battery compartment lid and remove the lid
(2).
Insert the non-rechargeable batteries or fully
2
charged rechargeable batteries.
Note:
D
Make sure the + and - poles of the batteries
point in the right direction.
5
16/08/17 10:46