Philips Avent SCD501/00 Benutzerhandbuch Seite 3

1 Introduction
Congratulations on your purchase and welcome
to Philips AVENT! To benefit fully from the
support that Philips AVENT offers, register your
product at www.philips.com/welcome. Read this
user manual carefully.
2 Important
Symbol for ‚follow instructions for use'.
2.0.1 Danger
•
Never immerse any part of the baby monitor
in water or any other liquid. Do not place
where water or any other liquid can drip or
splash onto it. Do not use in moist places or
close to water.
•
Never put anything on top of the baby
monitor or cover it. Do not block any
ventilation openings.
•
Cords present a potential strangulation hazard.
Keep cords out of the reach of children (more
than 1 metre/3.5 feet away). Never place the
baby unit inside the baby's bed or playpen.
4213_355_5006_2_DFU-Redesign_A5_v3.indd 3
2.0.2 Warning
•
Check if the voltage indicated on the adapters
of the baby unit and parent unit corresponds
to the local mains voltage before you connect
the appliance.
•
Only use Philips recommended adapter
(model S003PV0600050).
•
Do not modify and/or cut and/or change any
part of the adapter, this causes a hazardous
situation.
• Do not use the baby monitor if the adapter of
the baby or parent unit is damaged. Contact
the Philips Consumer Care Centre.
•
Do not unscrew the back panel of the baby
unit to prevent an electric shock.
•
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety. Children shall not
play with the appliance.
2.0.3 Caution
•
This baby monitor is intended as an aid. Do
not use it as a substitute for responsible and
proper adult supervision.
• Use the appliance at a temperature between
0°C (32°F) and 40°C (104°F). Store the
appliance at a temperature between -25°C
(-13°F) and 70°C (158°F).
•
Do not expose the baby unit and parent unit
to extreme cold or heat or to direct sunlight.
Do not put the baby unit and the parent unit
close to a heating source.
• Never cover the parent unit and the baby unit
with anything (e.g. a towel or blanket).
•
Always place batteries of the correct type in
the parent unit (see 'Inserting the batteries' in
chapter 'Preparing for use').
•
If you place the parent unit or the baby
unit next to a transmitter or other DECT
appliance (e.g. a DECT telephone or wireless
router for the internet), the connection
may be lost. Move the baby unit or parent
unit further away from the other wireless
appliances until the connection is restored.
3
16/08/17 10:46