Operation; Maintenance And Cleaning; Technical Data - VOLTCRAFT DL-131G Bedienungsanleitung

OPERATION

a) Logging the measurement
Before you use the vibration logger, program it using the software Voltsoft Standard or Profes-
sional. To this end, follow the instructions of the software.
The recording can be done manually or automatically.
For manual recording, press and hold the "4" button for at least 2 seconds. The green LED "2"
blinks four times. Afterwards, the logging process starts automatically and the green LED "2"
fl ashes every 10 seconds.
In automatic mode the vibration logger starts the recording automatically when the time
preset with the Voltsoft software has passed. The green LED "2" blinks every 10 seconds.
Once the preset recording time is reached, the recording is terminated automatically.
After carrying out the settings in the Voltsoft software, the vibration logger can also record
values automatically when it detects vibrations and blows.
All values will be saved after the recording.
You can terminate the recording in each mode by pressing the "4" button for at least 2
seconds.
Once the internal memory is full, both LEDs fl ash every 60 seconds. Read the logged meas-
uring results using the Voltsoft software and delete the internal memory.
b) Reading out the values
1. Connect the Voltsoft Software and connect the data logger to the computer. Follow the
instructions of the software manual (chapter 3).
2. Disconnect the data logger from the USB port of your computer after reading out the
values.

MAINTENANCE AND CLEANING

The vibration logger requires no servicing on your part, apart from any occasional replace-
ment of the battery.
Never clean the data logger while it is in the logging or reading mode.
Use a clean, dry, soft cloth for cleaning. Do not use aggressive cleaning agents, as these
can cause discolouration. Do not press too strongly on the surface when cleaning, to prevent
scratch marks.
DISPOSAL
a) General instructions
Dispose of an unserviceable product in accordance with the relevant statutory
regulations.
b) Batteries
You as the ultimate consumer are legally obliged (Regulation on Spent Batteries) to return all
dead batteries and accumulators. Disposal in the household waste is prohibited.
Contaminated rechargeable batteries are labelled with these symbols to indicate
that disposal in the domestic waste is forbidden. The symbols of the relevant heavy
metals are: Cd = Cadmium, Hg = Mercury, Pb = Lead. You can return your used
batteries/rechargeable batteries free of charge to the offi cial collection points in your
municipality, in our stores, or anywhere where batteries or rechargeable batteries
are sold.

TECHNICAL DATA

Data logger ...........................................DL-131G
Operating voltage .................................3.6 V lithium battery
Battery life: ............................................ >1000 h
Measuring range ...................................vibration/acceleration ± 18 G
Measuring interval ................................50 ms – 12 h
Memory for measuring data ..................8 Mbit
Dimensions ...........................................95 x 28 x 21 mm (L x W x H)
Weight ..................................................30 g
Impressum /legal notice in our operating instructions
These operating instructions are a publication by Voltcraft ® , Lindenweg 15, D-92242 Hirschau/Germany, Phone +49 10 96 04 / 40 87 80
(www.voltcraft.de).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming, or the capture in electronic data processing
systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2013 by Voltcraft ®