Technical Data - fidek FPA-10A Bedienungsanleitung

Introduction
Dear Customer,
Thank you for purchasing this FIDEK power amplifier.
By purchasing this power amplifier you have invested in a product that has been
designed with state-of-the-art technology.
The product is designed in conformity with protection class I. In addition, the
appliance is fitted with noise suppression. This product therefore meets the
requirements of the applicable European and national directives. Its conformity
has been certified and the corresponding declarations and documents are kept
with the manufacturer.
You, as the user, must observe these operating instructions to maintain this status
and ensure safe operation.
For a fast response of your technical enquiries please use the
email
address listed below.
Germany: Fon.
Fax
e-mail:
Mon to Thurs 8.00am to 4.30pm
Fri
22
+ 49 9604/40 88 80
+ 49 9604/40 88 48
tkb@conrad.de
8.00am to 2.00pm

Technical data

Operating voltage
Power consumption
Fuse
Input sensitivity
Input impedance
Output power
Frequency response
Distortion factor
S/N ratio
Channel separation
Subwoofer duplexer
LOW CUT filter
Dimensions
Mass
230 V~/50 Hz
2800 W (max.)
T10 A/250 V (6.3 x 32 mm)
1 V
10 kOhm (asymmetrical)
20 kOhm (asymmetrical)
2 x 450 W at 8 Ohm
2 x 720 W at 4 Ohm
2 x 1000 W at 2 Ohm
1 x 1350 W at 8 Ohm
1 x 1800 W at 4 Ohm
10 – 49.000 Hz (+/- 1 dB)
< 0,05%
> 100 dB
> 60 dB
40-200 Hz/12 dB/Oct.
30/50 Hz/12 dB/Oct.
472 x 102 x 446 mm
21 kg
39