Herunterladen Inhalt Inhalt Diese Seite drucken

Tunze Osmolator 3155 Gebrauchsanleitung Seite 15

Vorschau ausblenden Andere Handbücher für Osmolator 3155:
Inhaltsverzeichnis

Werbung

Positioning the sensors in the aquarium
Use with Magnet Holder 3155.600 on the edge of
the aquarium (1). The switching distance from the
normal water level to the safety shut-down level
(too high) is 25 mm (.98 in.) in this arrangement.
Avoid direct radiation of light by mercury discharge
lamps and the vicinity of air ejectors; a strong
growth of algae may disturb the function ! The
safety sensor (with the cable pointing down) and the
operating sensor (with the cable pointing upwards)
are placed on the same magnet holder.
Use with a Magnet Holder 3155.600 on the edge of
the covered aquarium (2).
Caution ! The water has to be able to rise to at
least 25 mm (.98 in.) above the normal water
level as otherwise the safety shut-down is not
guaranteed (3).
After fitting the sensors, check the overflow function:
The switching point of the overflow protection sensor
(with the cable pointing down) should not be above
the edge of the glass tank ! The sensors should
always be attached horizontally (see illustrations).
Placement des capteurs en aquarium
Fixation avec Magnet Holder 3155.600 au bord de
l'aquarium (1). La différence entre le niveau normal
(Level) et le niveau du déclenchement de sécurité
(Too high) atteint ici 25mm.
Evitez le placement à proximité d'une source
HQI puissante ou d'un diffuseur d'air, la forte
croissance induite d'algues pouvant perturber
le fonctionnement ! Le capteur de sécurité (sortie
de câble vers le bas) et le capteur de régulation
(sortie de câble vers le haut) sont fixés sur le même
Magnet Holder.
Fixation avec Magnet Holder 3155.600 au bord
d'un aquarium avec galerie (2)
Attention ! Le niveau d'eau doit pouvoir s'élever à au
moins 25mm au-dessus du niveau normal (Level),
la commutation du capteur de sécurité ne serait
plus assurée dans le cas contraire (3).
Après montage des capteurs, vérifiez la fonction
de sécurité : le point de commutation du capteur
de sécurité (sortie de câble vers le bas) ne
doit pas se situer plus haut que le bord de
l'aquarium ! Les capteurs doivent toujours être
positionnés horizontalement (voir illustrations).
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis