Safety Measures - Unitest Beha 2000 a alpha Bedienungsanleitung

(Transporting Tools). The voltage testers represent a valuable
support for all testing and measurement in handicraft and in-
dustrial applications as well as for household uses.
The voltage testers UNITEST 2000 are characterised
by the following features:
• Constructed in compliance with DIN EN 61243-3, DIN VDE
0682 Part 401 (previously DIN VDE 0680 Part 5), IEC61010
• Fixed test probe cover eliminates risk of injury (VBG 1, §
35 Transporting Tools)
• Digital LC-Display (only UNITEST 2000 b beta und UNI-
TEST 2000
• Resistance measurement (only 2000
• LED (UNITEST 2000 alpha)
• DC and AC voltage measurement up to 690V
• Single-pole phase test
• Continuity test / diode test
• Double-pole rotary direction determination
• IP 65 (IEC 60529, EN 60529, DIN VDE 0470-1)
After unpacking, verify that the instrument is unda-
maged. The scope of supply comprises:
1 UNITEST 2000α (alpha), β (beta) or
2 Batteries 1,5V IEC LR03 AAA
1 Instruction manual

2.0 Safety Measures

The instruments UNITEST 2000 have been constructed and ve-
rified in compliance with the safety measures for voltage te-
sters DIN EN 61243-3, DIN VDE 0682 Part 401 (previously DIN
VDE 0680 Part 5), EN 61010, and IEC 61010 and have left the
factory in safe and perfect condition.
In order to avoid electrical shock, the valid safety and VDE
regulations regarding excessive contact voltages must
receive utmost attention, when working with voltages ex-
ceeding 75V (60V) DC or 50V (25V)rms AC. The values
in brackets are valid for spezial ranges (for example me-
dicine and agriculture).
Prior to measurement ensure that the test leads and the
test instrument are in perfect condition.
When using this instrument only the handles of the pro-
bes may be touched .
This instrument may only be used within the ranges spe-
cified (see 6.0 Technical Data) and within voltage sy-
stems up to 690V
Prior to usage ensure perfect instrument function (e.g.
on known voltage source).
The voltage testers may no longer be used if one or se-
veral functions fail or if no functionalityis indicated.
Do not measure under damp conditions.
Perfect display is only guaranteed within a temperature
range of -10°C up to + 55°C, at relative humidity <85%.
If the operator's safety cannot be guaranted, the instru-
ment must be removed from service and protected
against use.
The safety can no longer be insured if the instrument:
•
shows obvious damage
•
asurements
•
conditions
transport. All relevant statutory safety regulations must be ad-
hered to when using this instrument.
12
γ
gamma)
has been stored for too long under unfavourable
has been subjected to mechanical stress during
•
does not carry out the desired me-
γ
gamma)
γ
(gamma)