Transport And Storage; Operator´s Safety - Unitest TELARIS ERDE Bedienungsanleitung

Operator´s Safety
Scope of Supply:
1 pc TELARIS EARTH CAT No. 8986
1 pc test lead, black
1 pc test lead, blue
1 pc crocodile clamps, black
1 pc crocodile clamps, blue
1 pc carrying holster
6 pc batteries 1.5V Mignon Type IEC LR6 (Size AA)
1 pc instruction manual

2.0 Transport and Storage

Please keep the original packaging for later trans-
port, e.g. for calibration. Any transport damage due
to faulty packaging will be excluded from warranty
claims.
In order to avoid instrument damage, it is advised
to remove batteries when not using the instrument
over a certain time period. However, should the in-
strument be contaminated by leaking battery cells,
you are kindly requested to return it to the factory
for cleaning and inspection.
Instruments must be stored in dry and closed areas.
In the case of an instrument being transported in ex-
treme temperatures, a recovery time of at least 2
hours is required prior to instrument operation.
3.0 Operator´s Safety
The UNITEST TELARIS Earth has been designed and
checked in accordance with the safety regulations
for Electronic test and Measurement and left our
factory in a safe and perfect condition. In order to
maintain this condition and to ensure safe opera-
tion, the operator must respect the references and
warnings contained in this instruction manual.
The respective accident prevention regulations
established by the professional associations
for electrical systems and equipment must be
strictly met at all times.
20
Measurements in dangerous proximity of elec-
trical installations are only to be executed when
instructed by a responsible electrical special-
ist, and never alone.
Prior to usage, inspect instrument and test
leads for external damage.Prior to any opera-
tion, ensure that the connecting leads used and
the instrument are both in perfect condition.
If the operator's safety can no longer be guar-
anteed, the instrument is to be put out of ser-
vice and protected against use. The safety is no
longer guaranteed, if theinstrument:
• shows obvious damage
• does not carry out the desired measurements
• has been stored for too long under un-
favourable conditions
• has been subjected to mechanical stress dur-
ing transport.
The instrument may only be used within the op-
erating ranges as specified in the technical data
section.
Avoid any heating up of the instrument by di-
rect sunlight to ensure perfect functioning and
long instrument life.
The instrument may only be connected to volt-
age free earth connectors!