Installation; Operation Telephone - Topcom Allure 130 Bedienungsanleitung

ALLURE130 LD DEF BOOK Page 1 Tuesday, June 11, 2002 2:48 PM
1. I
NSTALLATION
Put 2X 1,5V AAA batteries inside the battery compartment to activate the display of the
telephone. Take the following steps to install a battery :
1. Use a screwdriver to open the battery compartment.
2. Put the batteries inside the battery compartment.
3. Close the battery compartment carefully.
When you install the batteries, the telephone line must be pluged out of the phone.
2. K
EYS
1. Numerical Keys
2. Memory button
3. Program button
4. Hold button
5. Flash button
6. Redial/Pause button
7. Handsfree button
3. O
PERATION TELEPHONE
3.1. Handsfree calling
It is possible to make a handsfree telephone call with the Allure 130:
• Press the Handsfree button
• Enter the desired telephone number
Note :The volume of the speaker can be set by means of the Handsfree Volume
buttons.
3.2. Setting the ringer volume
The ring volume switch is located at the bottom of the phone. You can choose between
high ( ) or low ( ).
3.3. Flash (R)
Press the Flash button (R) to activate certain services as 'Call Waiting' (if this service is
provided by your telephone company); or to transfer phone calls when you are using a
telephone exchange (PABX).
You can set the desired flash time by means of the Flash time switch at the bottom of the
phone. You can choose between 100, 300 and 600 ms.
3.4. Last number redial
If you want to call back the last dialled telephone number, pick up the handset and press
the Redial button
3.5. Conversation on Hold.
It is possible to deactivate the microphone during a conversation by pressing the Hold
button. You can now talk freely without the caller hearing you. The caller will hear music on
Hold. Press the Hold button again if you want to resume your conversation.
8. Handsfree volume control
9. Clock button
10. Time adjust button
11. Direct Memory buttons
12. Ringer volume switch
13. Puls-tone switch
14. Flash time switch
to activate/deactivate the handsfree function.
.. The telephone number will be dialled automatically.