TIPTEL 134 Bedienungsanleitung Seite 24

SETTING UP
Scope of delivery
Phone with handset incl. coil cord
Line cord RJ11 – RJ11
Wall mount bracket, manual, 4 x AAA batteries
Installing Batteries
Note: Before installing or changing the batteries make sure that the
telephone is not connected to the telephone network.
To open the battery door and install the batteries, follow the procedure
below:
1. Open the battery case on the bottom of the unit by using the tip of
a pen to lift the latch.
2. Install the 4 AAA batteries into the battery compartment observing
the correct polarity.
3. Close the battery compartment.
Low Battery Alert
This unit will alert you when the batteries need replacement. When the
battery power becomes low the battery low icon (
display. When you need to replace batteries in the future always use
high quality AAA batteries. The batteries are needed for memory
backup.
Connecting the Phone
1. Connect the coiled cord to the jack in the handset and the side of
the base.
2. In case you bought an AC adapter connect one end of the adaptor
to the DC 9V jack on the rear of the unit, and the other end to
electric wall plate.
Attention: All functions using the display are not available without
batteries or an AC adapter. Storing and use of the short dial memory
works in off-hook mode only. Hands-free mode may be used if you lift
the handset shortly after first connecting the phone to the telephone
line. Thus, enough power is provided to run the loudspeaker.
Use of batteries or an AC power adapter ( DC 9V, 200 mA min, take
care of the polarity) is recommended.
) will be lit on the