Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Safety Information; Check Contents Of Pack; Connecting The Telephone Handset - switel crt 7 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3

Installation

3.1

Safety information

NOTE! Before installation, it is essential that you read the general information at the beginning of this
user guide.
3.2

Check contents of pack

The following items are supplied in this pack:
One telephone base
One telephone line cord
One power adaptor
This user guide
3.3

Connecting the telephone handset

After unpacking your telephone, connect the telephone handset to the base unit. First take one end of
the curly cord and plug it into the socket on the handset. Take the other end of the curly cord and plug it
into the socket on the side of the telephone base unit.
3.4

Insert batteries (supplied)

Install the batteries before connecting your telephone to the telephone socket or power supply. In case
of AC power failure, the batteries are required for the clock display to function. However, the radio and
alarm will not operate without mains power.
1.
Make sure that the telephone is not connected to the telephone network.
2.
Locate the battery compartment on the underside of your telephone.
3.
Open the battery compartment with a pen tip or a pointed object.
4.
Insert the batteries, ensuring that the polarity is correct.
5.
Close the battery compartment.
The batteries must be changed when the display starts to dim.
Do not use rechargeable batteries, as these could possibly lead to a short circuit. When replacing the
batteries use AAA 1.5V alkaline batteries. Do not throw batteries into fire or immerse in water. Do not
dispose of old or faulty batteries with the normal household waste. Before installing or changing the
batteries, make sure that the telephone is not connected to the telephone network.
3.5

Connect Mains Power Supply

Connect the AC adaptor to the power socket and plug the cable into the jack marked DC 12V on the
back of the telephone. The power LED comes on to indicate the power supply is good. The battery
should always be installed, even when using the mains power supply, to protect against power
interruption.
36
- Installation -
One telephone handset
One curly cord
Two AAA batteries
One warranty card

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis