Starting Operation - Bosch PSM 18 LI Betriebsanleitung

OBJ_BUCH-1201-001.book Page 21 Monday, May 31, 2010 1:04 PM
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different
sanding sheets are available:
For the working of all
wooden materials
For coarse-sanding, e. g.
of rough, unplaned beams
and boards
For face sanding and plan-
ing small irregularities
For finish and fine sanding
of wood
For the working of paint/
enamel coats or primers
and fillers
For sanding off paint
For sanding primer
For final sanding of prim-
ers before coating
For reworking or polishing, especially of metal
and stone, use fleece/polishing cloth pad.
Depending on the desired surface quality of the
workpiece, different fleece types or polishing
cloth pads are to be used.
Replacing the Sanding Plate
(see figure F)
Slide the SDS button for release of the sand-
ing plate 6 all the way to the right.
Remove the sanding plate 5.
Guide the sanding plate 5 from below
against the sanding plate holder and firmly
press them together.
Slide the SDS button for release of the sand-
ing plate 6 all the way to the left.
If, e. g., the front tip of the sanding sheet is
worn, you can also remove the complete sand-
ing plate and reattach it turned by 120°.
Bosch Power Tools
Specialty Sanding Plates
You can replace the supplied sanding plate 5
with a specialty sanding plate, which is available
as an accessory.
Grain size
The specialty sanding plate is attached in the
same manner as the one supplied.
40—180
Attach and remove the respective sanding
sheets in the same manner as when changing
original sanding sheets.
coarse 40
Pad Extender (see figure G)
With the pad extender 14 you can sand surfaces
that are difficult to access, such as sills on win-
medium 80, 120
dows, cabinets or doors.
Pad Extender, Narrow (see figure H)
fine 180
With the narrow pad extender 15 you can sand
narrow openings, slots and passages.
40—180
Pad Extender, Narrow Rounded (see figure I)
The narrow rounded pad extender 17 allows you
to sand curved and hollow areas or surfaces that
are curved inward, such as on furniture, rails or
coarse 40
heating radiators.
medium 80, 120
fine 180
Operation

Starting Operation

Inserting the Battery
Use only original Bosch lithium ion batter-
ies with the voltage listed on the nameplate
of your power tool. Using other batteries can
lead to injuries and pose a fire hazard.
Switching On and Off
To start the machine, push the ON/Off switch 8
downward to position "1".
To switch off the machine, push the On/Off
switch 8 upward to positon "0".
Battery Charge-control Indication
The battery charge-control indicator 7 indicates
the charge condition of the battery when the
machine is switched on. It consists of 3 green
LEDs.
English | 21
2 609 004 215 | (31.5.10)