Brother PRWT 1 - Table Set Handbuch Seite 5

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Removing the table
1 Loosen the two thumb screws, lift up the
table, and then pull it off toward you.
1 Thumb screw
2 Carefully pull out the table so that it does
not hit the machine.
3 After the pins on each side reach the notches
in the guide plates, raise the table to lift the
pins up through the notches.
1 Pin
2 Notch
Remove the table from the machine.
Slightly tighten the thumb screws on the
4
table to prevent loss.
4/4