Brother PRWT 1 - Table Set Handbuch Seite 3

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
4 Using the included wrench, firmly tighten
each hexagonal support screw (two on each
side).
5
Align the holes in the right table bracket
with the hexagonal support screws on the
right side of the machine.
1 Hexagonal support screws
2 Holes in right table bracket
6 Align the right table bracket with the holes
in the two hexagonal supports, insert the
screws and lightly tighten to hold the
bracket in place.
1 Screws
7 Attach the left table bracket following steps
5 6
and for the left side.
8 Using the Phillips screwdriver included with
your machine or one of your own, firmly
tighten all screws.
The right and left table brackets are
installed on the machine.
Memo
● Even if you sew without using the table,
you can leave the brackets attached.
2/4