Multiplex 21 4215 Anleitung Seite 15

Examine your kit carefully!
MULTIPLEX model kits are subject to constant quality checks throughout the production process, and we hope that you
are satisfied with the contents of your kit. However, we would ask you to check all the parts before you start
construction (using the Parts List as a guide), as we cannot exchange components which you have already
worked on. If you find a part is not acceptable for any reason, please take it back to your supplier (model shop), as he
is your first port of call. After checking, he will send the part or the kit to our Quality Control department. Please be sure
to include the purchase receipt and a brief description of the fault, otherwise we cannot process your complaint.
We are constantly working on improving our models, and for this reason we must reserve the right to change the kit
contents in terms of shape or dimensions of parts, technology, materials and fittings, without prior notification. Please
understand that we cannot entertain claims against us if the kit contents do not agree in every respect with the
instructions and the illustrations.
Caution!
Radio-controlled models, and especially model aircraft, are by no means playthings. Building and operating
them safely requires a certain level of technical competence and manual skill, together with discipline and a
responsible attitude at the flying field. Errors and carelessness in building and flying the model can result in
serious personal injury and damage to property. Since we, as manufacturers, have no control over the
construction, maintenance and operation of our products, we are obliged to take this opportunity to point out
these hazards and to emphasise your personal responsibility.
Additional items required:
e.g. MULTIPLEX Micro IPD receiver
alternatively:
MULTIPLEX RX-7 Synth DS IPD receiver
MULTIPLEX Nano S servo
Tiny-S
Servo extension lead
"AcroMaster" power set, HiMax HC 3516-1130
Contents: 1 HC 3516-1130 motor
1 11 x 5.5" APC propeller
1 5 mm Ø collet propeller driver
1 speed controller, e.g. Castle Creations Phoenix 45A
Flight battery:
MULTIPLEX flight battery, e.g. LiBATT 2100 mAh - 3200 mAh, 3 cells (maximum load approx. 40 A)
Adhesive: cyano-acrylate
Use any type of medium or thick cyano-acrylate adhesive ("cyano", "CA"). Do not use styrofoam cyano. Epoxy
adhesives produce what initially appears to be a sound joint, but the bond is only superficial, and the hard resin breaks
away from the parts under load. White glue is entirely unsuitable. However, hot-melt adhesive from a glue gun ("HM") is
a very useful alternative - especially for mounting servos.
Tools:
Scissors, balsa knife, combination pliers, long-nose pliers, cross-point / slot-head screwdrivers (for servo output arms).
Specification:
Wingspan
Overall fuselage length
All-up weight min.
Wing area
Wing loading (FAI) min.
RC functions
Note: please remove the illustration pages from the centre of the instructions.
(2 required for ailerons)
(2 required for rudder and elevator)
(2 required for aileron servos)
1095 mm
1150 mm
920 g
36.6 dm²
25 g / dm²
Aileron, elevator, rudder and throttle
GB
35 MHz A-band
40 MHz
35 MHz A-band
# 21 4215
Order No. 5 5971
Order No. 5 5972
Order No. 5 5885
Order No. 6 5120
Order No. 6 5121
Order No. 8 5031
Order No. 33 2631
15