Intended Use; For Your Safety; Noise/Vibration Information; Machine Elements - Bosch PWS 700 Bedienungsanleitung

Intended Use

The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is re-
quired.
For machines with electronic control: With ap-
proved sanding tools, the machine can be used
for sanding and polishing.

Noise/Vibration Information

Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 88 dB (A); sound
power level: 101 dB (A).
Wear hearing protection!
The typically weighted acceleration is 5.0 m/s
When using the vibration-dampening auxiliary
handle, the hand-arm vibration at the auxiliary
handle is typically below 2.5 m/s

Machine Elements

1 On/Off switch
2 Thumbwheel for speed preselection
(PWS 8-125 CE/PWS 850 CE/
PWS 9-125 CE)
3 Auxiliary handle
4 Spindle lock button
5 Grinder spindle
6 Protection guard
7 Clamping lever
8 Mounting flange (for the M 14 grinding
spindle with O-ring)
9 Grinding/cutting disc*
10 Clamping nut
11 quick-clamping nut
(for M 14 grinder spindle)*
12 Hand guard*
13 Rubber sanding pad*
14 Sanding sheet*
15 Round nut*
16 Cup brush*
17 Cutting guide with dust extraction protection
guard*
18 Diamond cutting disc*
19 Mounting flange M 10
* Not all of the accessories illustrated or described are
included as standard delivery.
15 • 1 609 929 F32 • 03.06
general safety notes in the enclosed booklet
must be observed. Before using for the first
time, ask for a practical demonstration.
2
.
2
.
English - 2

For Your Safety

Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
Wear protective glasses and hearing protec-
tion.
Wear additional protection equipment for your
safety, such as protective gloves, sturdy
shoes, hard hat and apron.
The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of
materials are particularly dangerous.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Always direct the cable to the rear away from
the machine.
Always switch the machine off and wait until it
has come to a standstill before placing it down.
For power outage or when the mains plug is
pulled, unlock the On/Off switch immediately
and turn it to the off position. This prevents un-
controlled restarting.
The machine must be used only for dry cutting/
grinding.
For all work with the machine, the auxiliary
handle 3 must be mounted.