Operating Determinations; Approval - Omnitronic DR-1000 MK2 Bedienungsanleitung

Never put any liquids on the device or close to it. Should any liquid enter the device nevertheless have it
checked by a qualified service technician before you operate it again. Any damage caused by liquids having
entered the device is not subject to warranty!
For cleaning, only use a soft lint-free and moistened cloth. Make sure not to allow any water to enter and
never use any solvent cleansers. Always disconnect from the mains, when the receiver is not in use or
before cleaning it.
Always plug in the power unit last. The receiver falls under protection-class III. The receiver always has to be
operated with an appropriate power unit.

3. OPERATING DETERMINATIONS

The DR-1000 MK2 is a PLL multifrequency receiver. The receiver makes up a wireless audio
transmission system together with the optional wireless microphone HM-1000 MK2 and the pocket
transmitter TM-1000 MK2. The system operates in the UHF range 740-764 MHz. The frequency range
is divided into 192 channels, which can be selected as desired with a 125 kHz frequency spacing. The
system can be expanded to up to 16 wireless transmission sets, which can be operated in parallel without
any intermodulation. The transmission range is approx. 100 m and depends on the local conditions. To
increase the range and interference immunity, it is possible to use two optional antenna boosters
AB-1000. For easy setup of a wireless transmission system with several receivers, the optional antenna
distributor UA-1000 is available. The distributor replaces the antennas and PSUs of up to four receivers,
and can also be used in connection with the antenna boosters.
The receiver is only allowed to be operated with the supplied power unit, which is allowed to be operated
with 100-240 V AC, 50/60 Hz. This device was designed for indoor use only. Never remove the serial
barcode from the device as this would void the guarantee.

3.1 Approval

This wireless microphone system was tested in accordance with the European standards EN 300422-2, EN
301489-01, EN 301489-09 and EN 60065. Consequently, this product adheres to the R&TTE directive of the
European Union and does not need an individual EC type examination of every member state. The notified
1856
body is
16/24 00053645.DOC, Version 1.0