What To Do If - Zanussi ZBF11420SA Benutzerhandbuch

2. Remove any stored food, wrap it in several
layers of newspaper and put it in a cool
place.
Caution! Do not touch frozen goods with
wet hands. Hands can freeze to the
goods.
3. Leave the
door open and
insert the
plastic scraper
in the appro-
priate seating
at the bottom
centre, placing
a basin under-
neath to collect the defrost water
In order to speed up the defrosting proc-
ess, place a pot of warm water in the
freezer compartment. In addition, remove
pieces of ice that break away before defrosting
is complete.
4. When defrosting is completed, dry the in-
terior thoroughly and keep the scraper for
future use.
5. Switch on the appliance.

What to do if...

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Problem
The appliance does not
operate. The Pilot light
does not flash.
The Pilot light flashes.
The Alarm light flashes.
16
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The appliance is not working prop-
erly.
The temperature in the freezer is
too high.
6. After two or three hours, reload the previ-
ously removed food into the compartment.
Warning! Never use sharp metal tools to
scrape off frost from the evaporator as you
could damage it.
Do not use a mechanical device or any artificial
means to speed up the thawing process other
than those recommended by the manufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Periods of non-operation
When the appliance is not in use for long peri-
ods, take the following precautions:
• disconnect the appliance from electrici-
ty supply
• remove all food
• defrost (if foreseen) and clean the appliance
and all accessories
• leave the door/doors ajar to prevent unpleas-
ant smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food in-
side from spoiling in case of a power failure.
Only a qualified electrician or competent
person must do the troubleshooting that is not
in this manual.
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Contact a qualified electrician.
Refer to "Excessive Temperature
Alarm"
Solution
www.zanussi.com