Technical Data - Zanussi ZBF11420SA Benutzerhandbuch

Problem
The compressor operates
continually.
The temperature in the
freezer is too low.
The temperature in the
freezer is too high.
There is too much frost.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
www.zanussi.com
Possible cause
The temperature is not set correct-
ly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too
high.
The room temperature is too high.
The Quick Freeze function is
switched on.
The temperature regulator is not set
correctly.
The Quick Freeze function is
switched on.
The temperature regulator is not set
correctly.
Many products are stored at the
same time.
Products are too near to each oth-
er.
Food is not wrapped correctly.
The temperature regulator is not set
correctly.
Height
Width
Depth
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
Refer to "Quick Freeze function".
Set a higher temperature.
Refer to" Quick Freeze function".
Set a lower temperature.
Store less products at the same
time.
Store products so that there is cold
air circulation.
Wrap the food correctly.
Set a higher temperature.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
880 mm
560 mm
550 mm
20 h
230-240 V
50 Hz
Solution
17