What To Do If - Zanussi ZFT11111A Benutzerinformation

3. Leave the door open and insert the plastic
scraper in the appropriate seating at the
bottom centre, placing a basin underneath
to collect the defrost water.
In order to
speed up the
defrosting proc-
ess, place a pot of
warm water in the
freezer compart-
ment. In addition,
remove pieces of
ice that break
away before defrosting is complete.
4. When defrosting is completed, dry the in-
terior thoroughly and keep the scraper for
future use.
5. Switch on the appliance.
6. Turn the Temperature Regulator to the <<
-18 °C >> position and leave to run for at
least 4 hours in quick freeze mode.
7. After 4 hours reload the previously re-
moved food into the compartments.
Warning! Never use sharp metal tools to
scrape off frost from the evaporator as
you could damage it.

What to do if...

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Only a qualified electrician or competent
person must do the troubleshooting that is not
in this manual.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Problem
The appliance is noisy
The compressor operates
continually
www.zanussi.com
Possible cause
The appliance is not supported
properly
The thermostatic control is set in-
correctly
Do not use a mechanical device or any
artificial means to speed up the thawing
process other than those recommended by
the manufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Periods of non-operation
When the appliance is not in use for long peri-
ods, take the following precautions:
1. disconnect the appliance from electricity
supply
2. remove all food
3. defrost and clean the appliance and all
accessories
4. leave the door/doors open to prevent un-
pleasant smells.
Important! If the cabinet will be kept on, ask
somebody to check it once in a while to
prevent the food inside from spoiling in case of
a power failure.
Important! The appliance operates
discontinuously, so the stopping of
compressor does not mean being no current.
That is why you must not touch the electrical
parts of the appliance before breaking the
circuit.
Check if the appliance stands stable
(all the four feet should be on the
floor)
Set a warmer temperature
Solution
45