Bi-Wire Connection; Connecting The Power Cable - Yamaha A-S3000 Bedienungsanleitung

■ Bi-wire connection

The bi-wire connection separates the woofer from the
combined midrange and tweeter section. A bi-wire
compatible speaker has four binding post terminals. These
two sets of terminals allow the speaker to be split into two
independent sections. This split connects the mid and high
frequency drivers to one set of terminals and the low
frequency driver to the other pair.
Example of a bi-wiring connection (L channel)
SPEAKERS L CH
A OR B:4 MIN./SPEAKER A + B:8 MIN./SPEAKER
Rear panel of A-S3000
Caution
To use the bi-wire connections, the impedance of each speaker
must be 8 Ω or higher.
Note
Remove the shorting bars or bridges to separate the LPF (low
pass filter) and HPF (high pass filter) crossovers.
y
To use the bi-wire connections, switch the SPEAKERS selector
to the A+B BI-WIRING position.

■ Connecting the power cable

Plug the power cable into the AC IN inlet when all
connections are complete, and then plug in the power
cable to the AC outlet.
Speaker
TTENUATOR PHASE ATTENUATOR
PASS ATT. NORMAL INV. BYPASS ATT.
(-6dB) (-6dB)
TRIGGER
AC IN
IN
Rear panel of A-S3000
Supplied power cable
to an AC outlet
PHASE
NORMAL INV.
19
En