Connecting The Power Supply - Renkforce E-SA9M Bedienungsanleitung

(20) Effect loudspeaker output SURROUND
A mono loudspeaker surround signal (effect signal) is applied to this effect output when pressing the SURROUND
switch (10).
Here you can connect additional passive loudspeakers. These loudspeakers can be used as rear loudspeakers to
achieve a better spatial playback effect.
The white cinch socket of the amplifier is connected with the left, rear loudspeaker.
The red cinch socket of the amplifier is connected with the right, rear loudspeaker.
The rear speakers are switched in series.
This is why the surround outputs only work when both rear speakers are connected.
The minimum impedance per rear speaker is 4 Ohm per speaker.
The rear speakers carry an effect signal that strongly differs from the „normal" speaker signal
with respect to volume and sound. The surround effect depends on the stereo input signal of
the amplifier.
Cinch socket assignment:

Connecting the power supply

The amplifier's mains switch POWER (2) must be switched off.
• Connect the mains plug of the amplifier's mains cable to a socket (230V~/50Hz) linked to the public power supply
network.
32
-
+
Operating Instructions

English