Safety Instructions - Renkforce E-SA9M Bedienungsanleitung

Safety instructions

The guarantee/warranty will be void if damage is incurred resulting from non-compliance with
the operating instructions. Liability for any and all consequential damage is excluded!
Nor do we assume liability for damage to property or personal injury, caused by improper use
or failure to observe the safety instructions. In such cases the guarantee/warranty will be void.
Dear customer, The following safety instructions and risk information do not serve for protection of the
device but for protection of your health. Please read carefully through the following points:
• For safety and licensing (CE) reasons, unauthorised conversion and/or modifications to the product
are not permitted.
• All persons operating, installing, setting up, commissioning or servicing this device must be trained
and qualified correspondingly and observe these operating instructions.
• The device is designed according to protection class II. Only connect the amplifier to a normal mains
socket (230 V~/ 50 Hz).
• The device must be set up correctly. Please also follow these operating instructions.
• When setting up the product, make sure that the mains cable is not pinched or damaged by sharp
edges.
• If the amplifier or its connection cable is damaged, do not touch it. First of all, de-energize the
corresponding mains socket (e.g. via the respective circuit-breaker) and afterwards carefully pull the
mains plug from the socket. Do not use the product afterwards, but take it to a specialist workshop.
• The product is not a toy and should be kept out of reach of children! Children cannot judge the
dangers involved when handling electrical devices.
• Do not place any containers with liquid, e.g. buckets, vases or plants in the immediate proximity of
the product. Liquids could seep into the casing and in doing so impair the electrical safety of the
device. There is furthermore a high risk of fire or of a life-threatening electric shock. If this is the case,
de-energize the respective socket (e.g. switch off circuit breaker) and only then pull the plug-in mains
unit from the socket. Disconnect all cables from the device. Afterwards, the product must no longer
be used; take it to a specialist workshop.
• Never touch the mains plug of the amplifier with wet or damp hands. There is a risk of a fatal electric
shock.
25