Operation With External Devices; Operation With Integrated Mp3 Player - Renkforce E-SA9M Bedienungsanleitung

• With the switch SURROUND (10), you activate the SURROUND output on the back of the device.
When the switch is depressed (position „ON"), the surround loudspeakers are on. If the switch is not depressed
(position OFF), the device is turned off.
• If you operate the device with the remote control, always point this at the IR receiver (3) and make sure that there
are no obstacles between the remote control and the IR receiver (3), which may impair the transmission of the
commands.

Operation with external devices

• Switch on the signal sources such as CD players, cassette decks etc.
• With the input selection switch (9), select the desired input source (e.g. CD player).
• Start playback on your input source, if required.

Operation with integrated MP3 player

Please do not press the buttons of the MP3 control too fast in sequence. The device needs some
time to read and display the information of the storage media or to execute commands.
If the device does not react immediately to an input, this is not an error but indicates that
information is still being requested from the storage medium.
• Turn the input selection switch (9) to the position USB/CARD.
• Insert an SD or MMC card into the SD/MMC card reader (7) or a USB storage medium into the USB connection
(8).
• The content of the storage medium is imported.

The respective last inserted medium is always activated.
• If both a memory card AND a USB medium are inserted, you can switch between the two interfaces with the button
SD/USB (29) on the remote control.
• Press the button      /     (6) to start playback. Press the button again to interrupt playback.
• Press the button  (31) to select the next folder on the storage medium. Playback starts with the first track of
the selected folder.
• Press the button  (26) to select the previous folder on the storage medium. Playback starts with the first track
of the selected folder.
35