Operation - DeWalt XR Li-ION DCR016 Betriebsanleitung

1. Release the latch (i) to open the battery
compartment cover.
2. Insert the battery pack (n) into the receptacle
until it is fully seated.
3. Close and latch the battery compartment cover.
FUEL GAUGE BATTERY PACKS (FIG. 3)
Some D WALT battery packs include a fuel gauge
E
which consists of three green LED lights that
indicate the level of charge remaining in the battery
pack.
To actuate the fuel gauge, press and hold the fuel
gauge button (o). A combination of the three green
LED lights will illuminate designating the level of
charge left. When the level of charge in the battery
is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the
charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based
on product components, temperature and end-user
application.
To Install the Coin Cell Battery
(fi g. 1, 2)
WARNING: When replacing battery,
replace it with the same brand and type.
Observe correct polarity (+ and –) when
replacing batteries. Do not store or
carry batteries so that metal objects can
contact exposed battery terminals.
Your radio is equipped with memory capacity in
order to store the time and your selected memory
channels. When the radio is OFF, this memory
capacity is powered by one coin cell battery that is
included with the radio.
1. Turn the radio off and unplug from the power
source.
2. Open the battery compartment by lifting the
battery compartment latch (i).
3. Unscrew the screw (p) on the battery door (l).
4. Press down on the battery door latch and pull
to open.
5. Install the coin cell battery (m) according to the
diagram inside the coin cell battery area.
6. Replace the battery door, insert screw and
tighten.
7. Securely close the battery compartment.
NOTE: To reset the LCD display, clock and presets,
remove the coin cell battery and re-install it. Follow
this procedure if the screen seems to lock in place.

OPERATION

Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: Do not place the radio in
locations where it may be exposed to
dripping or splashing.
AC Operation (fi g. 4)
Unwrap power cord and plug into 110 or 230 V AC
wall outlet.
Operating the Radio (fi g. 1)
POWER/VOLUME ADJUSTMENT
1. To turn the radio on, press the power button (a).
2. Turn the dial (b) clockwise to increase the
volume. To decrease the volume, turn
anticlockwise.
MODE FUNCTION
To choose one of the mode functions (FM, AM, or
AUX), push the mode button (d) until the desired
function is found. For example, if the radio is on FM,
seen in upper left portion of LCD display (h), push
the mode button twice to change to AUX.
TUNE OR SEEK FUNCTION
There are two methods for finding the desired
frequency.
To Tune: Push the right arrow to move the tuner up
the frequency band. Push the left arrow to move the
tuner down the frequency band.
To Seek: Press the right arrow button (c) once and
release. The tuner frequency will increase to seek the
first radio station with acceptable clarity and stop at
that station. The right arrow button may be pressed
again to continue seeking a radio station at higher
frequencies. The left arrow button may be pressed
to seek radio stations at lower frequencies. The seek
function is available in AM and FM modes.
TO PROGRAM THE MEMORY BUTTONS
Ten FM and five AM radio stations may be
independently set. After programming the buttons,
pressing 1, 2, 3, 4 or 5 will instantly change the
frequency to the preset station.
1. Turn power on.
2. Set the radio to desired station (see Tune or
Seek Function).
EN GL IS H
27