Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setup and Assembly
Loop the drive belt around the sub-platter and then
around the motor pulley.
Avoid oil or grease coming into contact with the belt,
pulley or sub-platter. If necessary, these parts can be
cleaned with glass cleaner or pure alcohol and a lint-
free cloth.
The belt tension is factory-adjusted. If it needs to be re-
adjusted (e.g. to compensate for gradual belt stretch),
loosen the three locking screws of the eccentric motor
support ring and carefully rotate the ring.
If the belt tension is changed, the platter speed will
need to be reset.
➔ Page 27
The drive belt should be replaced every few years.
Thorens replacement belts are available from any
Thorens dealer or distributor.
➔ Fig. 2
➔ Fig. 2
Fig. 2
25
Werbung
Inhaltsverzeichnis
