Technics SB-C500 Bedienungsanleitung Seite 31

A
1 2
15mm
Skre ˛cone
Zkrut'te
Note
Before making the connections, switch OFF the power to the
●
receiver (or amplifier).
Check the input impedance and output power of the receiver
●
before making any connections. ( a See "Speaker impedance and
allowed output" on page 12.)
Be sure to connect only positive (+) wires to positive (+) terminals,
●
and negative (–) wires to negative (–) terminals.
Connection of speaker cables
Note
To prevent damage to circuitry never short-circuit positive (+) and
negative (–) speaker wires.
If using a commercially available 4-mm plug cable
Fully tighten the speaker terminal nut, and then insert the end of the
plug cable into the top of the nut.
SB-C500 SB-S500
When these speakers are connected to a receiver in order to
enjoy the Dolby Pro Logic System, be sure to set the center
mode on the receiver to the "NORMAL" setting.
a
3
Nie!
A
B
B
NE!
Note
Before making the connections, switch OFF the power to the
●
receiver (or amplifier).
Check the input impedance and output power of the receiver
●
before making any connections. ( a See "Speaker impedance and
allowed output" on page 12.)
Be sure to connect only positive (+) wires to positive (+) terminals,
●
and negative (–) wires to negative (–) terminals.
Connection of speaker cables
Note
To prevent damage to circuitry never short-circuit positive (+) and
negative (–) speaker wires.
If using a commercially available 4-mm plug cable
Fully tighten the speaker terminal nut, and then insert the end of the
plug cable into the top of the nut.
SB-C500 SB-S500
When these speakers are connected to a receiver in order to
enjoy the Dolby Pro Logic System, be sure to set the center
mode on the receiver to the "NORMAL" setting.
a
A
B
31