Playing Back Audio Files Stored On Components On The Network; Playing Back Your Favorite Songs; Network Setup Menu - Pioneer X-HM70-S Bedienungsanleitung

Playback with NETWORK feature
Playing back audio files stored on
components on the network
You can perform the following operations with the remote
control of this receiver. Note that some buttons are not
available for operation depending on the category currently
being played back.
• Press NETWORK to switch the remote control to the
NETWORK operation mode.
O

Playing back your favorite songs

Registering audio files and Internet radio stations
 While Playing back a song, press / to select "Add to
Favor", and then press ENTER.
The selected song is then registered in the Favorites folder.
Note that only the audio files stored on components on the
network can be registered.
Playing and deleting audio files and Internet radio
stations in and from the Favorites folder
1 Select 'Favorites' from the Main Menu.
Main Menu
Internet Music
Now Playing
Radio Library
Favorites Settings
2 Use / to select audio file or Internet radio station,
and then press ENTER.
3 Use / to select playback or delete options and then
press ENTER.
 – Selected item will begin playing
 – Deletes selected item from Favorites folder
• Select to undo previous operation.

Network setup menu

Setting up the network to listen to Internet radio on this
receiver.
1 Select 'Settings' from the Main Menu.
Main Menu Settings
Internet Music
Now Playing
Radio Library
Favorites Settings
2 Select the setting you want to adjust.
• Network – Adjust settings for the network (see Network
settings below).
• General – Use to reset all network connection settings to
their initial, factory-setting condition (see General settings
on page 22).
Network settings
In case the router connected to the LAN terminal on this
receiver is a broadband router (with a built-in DHCP server
function), simply turn on the DHCP server function, and you
will not need to set up the network manually. You must set up
the network as described below only when you have
connected this receiver to a broadband router without a
DHCP server function. Before you set up the network, consult
with your ISP or the network manager for the required
settings. It is advised that you also refer to the operation
manual supplied with your network component.
1 Select 'Network' from the Settings menu.
Settings
Network
General
2 Select 'Modes' from the Network Settings menu.
In case you make changes to the network configuration
without the DHCP server function, make the corresponding
changes to the network settings of this receiver.
Network
General
1 of
1
• DHCP (default setting) – Select if the server is DHCP
compatible.
When DHCP is selected, connection will begin
-
automatically. Connection is complete when network
connection details are displayed. Press ENTER to return
to the previous screen.
• STATIC – To connect to the server manually, follow the
instructions listed below.
Press  to delete the immediately preceding character.
-
Press  to switch between character types.
-
Press / to choose the desired character from those
-
displayed and press ENTER.
- Once input is complete, or if you wish to cancel the
input operation, press  until OK/CANCEL is
displayed, then use / to choose either OK or
CANCEL and press ENTER.
Note
• If STATIC is selected, the settings will be as follows.
Network Settings
Modes
Status
1 of 1 of
1 1
Network Modes
DHCP
STATIC
1 of
1
21
En