English; Location Of Controls; User Manual - AEG SRC 4321 Bedienungsanleitung

English

52

Location of Controls

1 iPod connection
2 TUNING+/TUNING- buttons
3 SET AL1 button (set alarm)
4 AL2 (2nd alarm time) button
5 SET AL2 button (set 2nd alarm time)
6 MIN button (minutes)
7 HR button (hours)
8 Alarm Interval/button for delayed switch-off
(SNOOZE/SLEEP)
9 TIME SET button
10 BBS button
11 FUNCTION Operation selection button
12 AL1 (alarm 1) button
13 STANDBY button
14 VOL+/VOL- volume control buttons
Back Side
15 DIMMER L/H switch
16 DC 15V connection
17 LINE IN jack
18 PHONE jack
19 DST 0/+1 switch (winter/summer time)
Remote Control
20 FUNCTION operation selection button
21 / buttons (search fwd/bwd)
22 (Play/Pause) button
23 BBS button
24 VOL+/VOL- volume control buttons
25 MUTE button
26 Delayed switch-off button (SLEEP)
27 POWER button
28 12/24 button (clock time mode)
First Use of the Device/ Introduc-
tion
• Before the fi rst use of the device, read the
user manual carefully.
• Select a proper place for the device such as
a dry, and even non slip area where you can
easily operate the device.
• Make sure the device is vented suffi ciently.
• If still in place, remove the protection foil from
the display.
SRC 4321 CD IM all languages 09252 52 SRC 4321 CD IM all languages 09252 52
Power supply
• Insert the grid plug into a properly installed
three prong socket with 230V, 50Hz. Connect
the device with the plug connector by inserting
its plug into the DC 15V jack (16) of the
device.
• Make sure the grid voltage corresponds to the
fi gures on the rating plate.
Attention:
• The plug connector included must only be
used with this device. Don't use for other
devices.
• Only use a power adapter with 15V
( ), a different adapter may damage
the device.
Note:
If the device is not used for an extended
period of time, the power adapter must be
removed from the socket.
Inserting the batteries
(Batteries are not included with the device)
In case of a power cut or if the device is un-
plugged, with batteries inserted, the settings
will be kept.
1. Open the battery case on the bottom of the
device.
2. Insert 2 R03 "AAA" batteries 1.5V. Mind the
correct polarity (indicated on the bottom of
the battery case).
3. Close the battery case.
4. If the device is not used for an extended
period of time, remove the batteries from the
device to avoid any leaking of battery acid.
Note:
If battery power is low or without batteries
inserted, the symbol "
display.
" appears on the
2008-9-30 18:18:54 2008-9-30 18:18:54