General Operation - AEG IMS 4452 Bedienungsanleitung

English
32
WARNING:
• Avoid contact with metallic objects. (Rings, nails, screws
etc.) Danger of short circuits!
• Short circuits may overheat or even ignite batteries.
This may lead to combustion.
• When transporting the batteries, cover the terminals for
your safety with an adhesive strip.
• If a battery leaks, do not rub the fluid into the eyes or
the skin. If acid comes into contact with the eyes, rinse
with purified water and seek medical advice if symp-
toms persist.
CAUTION:
Batteries must not be disposed of in the garbage. Please
bring used batteries to competent collection centers or
back to the dealer.
iPod/iPhone/iPad Compatibility
Due to the large variety of iPod and iPhone/iPad models and
generations on the market, full compatibility cannot be guar-
anteed. Before connecting your iPod/iPhone/iPad, ensure
that it has a compatible interface.
Full compatibility of the remote functions also cannot be
guaranteed. Operate your iPod/iPhone/iPad as normal, while
it sits in the docking station.
NOTE:
Depending on the software version of your iPhone the
following error message may be displayed:
"This accessory was not developed for iPhone use. It is
possible that noise occurs and signal strength is reduced."
In this case press "OK".

General Operation

Switch device on/off
• With the button (1), you can switch the unit between
standby and operating mode. In standby, the pilot lamp
(5 on the device) lights red.
Volume
By pressing the VOL+/VOL- buttons (6) you can adjust the
desired volume.
NOTE:
On the device, keep the keys \ and \ (2/3) pressed to
adjust the volume.
Infrared Remote Control
For wireless control within a distance of 5 m. If the distance
decreases you should change the batteries. For proper
operation mind a clear view between the remote control and
the sensor on the device.
Sound Settings
Change the EQ setting on your iPod/iPhone/iPad to produce
the best sound.
MUTE (9)
For immediate muting of the volume. Press MUTE again to
cancel the function.
NOTE:
The activated function cannot be displayed for technical
reasons.
Music Playback from iPod/iPhone/iPad
(iPod/iPhone/iPad not supplied)
CAUTION:
Switch off your iPod/iPhone/iPad before you connect it.
Refer to the instruction manual of your iPod/iPhone/iPad.
1. Insert your iPod/iPhone/iPad into the dock. The device
automatically switches to iPod mode.
CAUTION:
Make sure that your iPod/iPhone/iPad is plugged up-
right into the port. Do not bend or tilt the iPod/iPhone/
iPad whilst it is plugged into the port. This may cause
damage to the dock or the iPod/iPhone/iPad.
2. Playback starts after a short time.
Please be aware that playback can only start if the battery
on the unit connected to the socket has been charged to
a minimum level.
NOTE:
If you have not yet installed the application, the message
"This accessory requires an application you do not have
installed. Would you like to install it from the App store?"
appears on your iPod/iPhone/iPad. Depending on the
provider, downloading the app may require payment.
For details in regard to the application, refer to the
download portal of our web page
3. Depending on the iPod/iPhone/iPad Model, firstly re-
lease the button lock and start playing music if necessary
with the button (10).
4. Follow your iPod/iPhone/iPad manual for further use of
the controls.
CAUTION:
Switch off the device before you remove the iPod/iPhone/
iPad, as otherwise the iPod/iPhone/iPad could be dam-
aged.
NOTE:
If you have an incoming call when playing back music with
the iPhone docked, then playback stops and you can hear
the ring tone.
"www.sli24.de".